-7 -
For more information, visit www.desatech.com
TRIM ASSEMBLY
1. Slide top trim over the surround assembly. Secure frame
brackets with screws to the trim.
2. Slide the left trim from the bottom of the surround and
secure to the frame bracket with a screw. Repeat the
procedure with the right trim.
3. Insert both toggle switches into the square holes of the right
trim.
Note: The trims slide over the seven screws on the front
surface of the surround.
ATTACH SURROUND TO INSERT
The flange of the surround must go on the inside of the
insert’s flange. Four screws secure the surround to the insert.
Refer to the figure below.
PILOT ASSEMBLY ADJUSTMENTS
The pilot assembly is factory preset for the proper flame
height. Alterations to these settings may have occurred during
shipping and handling. If this is the case, some minor
readjustments may be necessary and should be done by a
qualified technician.
To access the pilot assembly, glass door must be open. The
proper settings for the thermopile height should be at a
distance of 3/8" to 1/2" from the pilot flame as shown below.
GLASS PANEL REMOVAL AND LOG SET
INSTALLATION
Before proceeding, make sure gas control valve is in the
"OFF" position.
1. To open the louver assembly, simply pull on the louver
spring latches towards the inside of the louver assembly, refer
to figure on page 4.
2. To open the glass door, undo both top latches located on
the middle and the right side of the firebox. The two lower
latches are located under the middle and right side of the
firebox.
For the top latch, place your left index finger on top of the
latch and your right index finger on the bottom of the latch.
Slowly pull the latch with your right index finger. At the same
time, apply some pressure with your left index finger.
This will prevent the latch from releasing quickly (Refer to the
following figure). Be careful when opening the latches since
they have springs.
4. Carefully swing the door to the left. The glass door is
securely mounted to the firebox by means of three screws.
TRIM ASSEMBLY
ATTACH SURROUND TO INSERT
PILOT ASSEMBLY
If the door is not completely closed, the microswitch
located in the middle (underside) of the firebox will not
properly operate and the main burner will not light.
