![background image](http://html1.mh-extra.com/html/desa/el36l/el36l_safety-information-and-installation-manual_2486345013.webp)
www.desatech.com
122663-01D
13
BACKLIGHT LED STRIP
1. Follow steps 1 through 4 under
Service
Preparation
, page 10.
2. Disconnect wires from backlight LED
strip.
3. Squeeze top of standoffs to remove back
-
light LED strip and discard.
4. Place new backlight LED strip onto stand-
offs and push gently.
5. Connect wires to backlight LED strip (see
Wiring Diagram,
page 14).
6. Follow steps 11 through 13 under
Service
Preparation
, page 10.
REMOTE CONTROL SENSOR
1. Follow steps 1 through 6 under
Service
Preparation
, page 10.
2. Disconnect wire from remote control sen-
sor board.
3. Squeeze top of standoffs to remove
board.
4. Gently push new board onto standoffs.
5. Connect wires to remote sensor board.
6. Follow steps 8 through 13 under
Service
Preparation
, page 10.
SETTINGS CONTROL BOARD
1. Follow steps 1 through 6 under
Service
Preparation
, page 10.
2. Disconnect wire from settings control
board.
3. Remove screws from bracket to remove
settings control board (see Figure 23).
4. Place new settings control board into posi-
tion making sure each control is aligned
with slot in panel. Install using screws
from step 3. DO NOT overtighten. This
will damage control board.
5. Reconnect wire to settings control board
(see
Wiring Diagram,
page 14).
6. Follow steps 8 through 13 under
Service
Preparation
, page 10.
Figure 21 - Replacing Backlight LED
Strip
Backlight
LED Strip
Standoffs
SERVICINg
Continued
Figure 23 - Replacing Settings Control
Board
Screw
Settings
Control
Board
Figure 22 - Replacing Remote Control
Sensor
Remote Control Sensor