![background image](http://html1.mh-extra.com/html/desa/comfort-glow-cgfp28n/comfort-glow-cgfp28n_owners-operation-and-installation-manual_2486323016.webp)
16
103413
UNVENTED (VENT-FREE) NATURAL GAS FIREPLACE
CGFP28N and CGFP28NT
INSTALLATION
Continued
INSTALLING LOGS
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install these
logs exactly as instructed. Do not modify
logs. Only use logs supplied with heater.
1.
Slide rear log (#1) into place behind
rear burner. Make sure flat areas at bot-
tom of log are behind rear burner (see
Figure 35).
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
Rear Log (#1)
Figure 35 - Installing Rear Log
Pressure Testing Fireplace Gas
Connections
1.
Open manual shutoff valve (see Fig-
ure 33, page 15).
2.
Open main gas valve located on or near
gas meter.
3.
Make sure control knob of fireplace is
in the OFF position.
4.
Check all joints from manual shutoff
valve to gas valve (see Figure 34, page
15). Apply mixture of liquid soap and
water to gas joints. Bubbles forming
show a leak.
5.
Correct all leaks at once.
6.
Light fireplace (see Operating Fire-
place, pages 17 and 18 [Thermostat-
controlled models] or pages 18 and 19
[Manually-controlled models]). Check
all other internal joints for leaks.
7.
Turn off fireplace (see To Turn Off Gas
to Appliance, page 17 [Thermostat-con-
trolled models] or page 19 [Manually-
controlled models]).
Figure 39 - Installing Fireplace Screen
Notches
Screws
for
Mounting
Screen
WARNING: You must operate
this fireplace with the fireplace
screen in place. Make sure fire-
place screen is in place before
running fireplace.
Figure 36 - Installing Bottom Mid Log
Figure 37 - Installing Front Log
Figure 38 - Installing Top Log
2
Tab
Bottom Mid Log (#2)
4
4
Top Log (#4)
3
Front Log (#3)
2 . Slide bottom mid log (#2) into place in
behind front burner. Make sure tabs at
bottom of log are behind front burner
(see Figure 36).
3.
Place front log (#3) into place in front
of bottom mid log (#2) (see Figure 37).
Make sure notches on bottom rest on
grate prongs.
4.
Finally place top log (#4) over bottom
mid log (#2) by matching the notches
under log (#4) with the raised blocks
of log (#2) (see Figure 38).
5.
Install fireplace screen by slipping
notches of fireplace screen over screws
on front of fireplace (see Figure 39).
CAUTION: Do not remove the
metal data plates attached to the
heater base assembly. The data
plates contain important warranty
information.