![background image](http://html1.mh-extra.com/html/desa/cld3924ntc/cld3924ntc_owners-operation-and-instruction-manual_2485786015.webp)
www.desatech.com
120890-01D
15
INSTALLATION
Continued
Pressure Testing Heater Gas
Connections
1. Open equipment shutoff valve (see Figure
14, page 14).
2. Open main gas valve located on or near
gas meter for natural gas or open pro-
pane/LP supply tank valve.
3. Make sure control knob of heater is in the
OFF position.
4. Check all joints from gas meter (natural
gas) or propane/LP supply to equipment
shutoff valve (see Figure 15, page 14
or Figure 16). Apply a commercial leak
detection solution to all joints. Bubbles
forming show a leak.
5. Correct all leaks at once.
6. Light heater (see
Operation
, page 16.
Check all other internal joints for leaks.
7. Turn off heater (see
To Turn Off Gas to
Appliance
,
page 17.
INSTALLING LOGS
WARNING: Failure to posi
-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
Figure 16 - Checking Gas Joints
(Natural Gas Only)
Gas
Meter
Equipment Shutoff Valve
Control Valve Location
CAUTION: After installa-
tion and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With the heater set to High, check
to see if flames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact
-
ing logs will create soot.
It is very important to install these logs exactly
as instructed. Do not modify logs. Only use
logs supplied with heater.
1. Place main log assembly (#1) onto base.
Cutout on front right will fit over burner
(see Figure 17). Make sure back of log
assembly is resting on back tabs of base.
There are 2 small notches on log that fit
onto front tabs.
2. Place front log onto grate. Log is notched
to sit over grate (see Figure 18, page
16). Position holes on bottom of log over
shoulder screws on base.
3. Place crossover log onto pins on main log
and front log (see Figure 19, page 16).
Note: Nontextured end of crossover log
faces back of firebox and will not be seen
from front of log set.
4. Add lava rock around base of heater if
desired. Do not place any lava rock on
logs or burner.
Figure 17 - Installing Main Log (#1)
Main Log Assembly
Back Tab
Burner
Front Tab
Sits on
Back Tab
Notch for
Front Tab
Notch
for Front
Tab
Cutout Fits
Over Burner
Front Tab
Shoulder
Screw