111160-01B
For more information, visit www.desatech.com
For more information, visit www.desatech.com
14
Dual Burner Biltmore Split Oak Models
CCL3018PTA/NTA, CCL3924PTA/NTA,
CCL3930PTB/NTB
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.
CAUTION: After installation and periodically there-
after, check to ensure that no flame comes in contact
with any log. With the heater set to HI, check to see if
flames contact any log. If so, reposition logs accord-
ing to the log installation instructions in this manual.
Flames contacting logs will create soot.
Each log is marked with a number. These numbers will help you identify
the log when installing. It is very important to install these logs exactly
as instructed. Do not modify logs. Only use logs supplied with heater.
1.
Place the front log (#1) on the grate fingers. Make sure the
front log rests firmly between the grate fingers and the grate
base (see Figure 24).
Figure 24 - Installing Front Log #1 (CCL3930PTB/NTB Shown)
Front Log (#1)
Grate
Fingers
Grate Base
INSTALLATION
Continued
Figure 21 - Installing Middle Log (#2)
Figure 22 - Installing Front Log (#3)
Figure 23 - Installing Crossover Log (#4)
Burner
Crossover Log (#4)
Notches
Rectangular
Knobs
Cutout
Tab
U-Shaped Slot
Middle Log (#2)
“U” Bend
3
Front
Log (#3)
Post
Post
Recess
3.
Locate the recesses on the back of the front log (#3). Fit these
recesses between the posts of the grate base (see Figure 22).
4.
Locate the notches in the bottom of the crossover log (#4). Place
the crossover log on top of the middle log and front log. Make
sure the notches of the crossover log lines up with rectangular
knobs on top of the middle and front logs (see Figure 23).
5.
Place lava rock around base of heater if desired. Do not put
lava rock on logs on burner.
INSTALLATION
Installing Logs (Cont.)
Figure 20 - Installing Back Log (#1)
Pin
Hole in Grate
Base
Back Log
(#1)
Burner
