www.desatech.com
123721-01E
19
iNsTallaTioN
Continued
oPeraTioN
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fire or explosion may result
causing property damage, per
-
sonal injury or loss of life.
A. This appliance has a pilot which must
be lighted by hand. When lighting the pi
-
lot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around
the appliance area for gas. Be sure to
smell next to the floor because some
gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
ASSEMBLING AND INSTALLING TRIM
1. Remove packaging from 3 pieces of
trim.
2. Locate 2 adjusting plates with set screws
and 2 shims in hardware packet.
3. Align shim under adjusting plate as shown
in Figure 24.
4. Slide one end of adjusting plate/shim
in slot on mitered edge of top trim (see
Figure 24).
5. Slide other end of adjusting plate/shim
in slot on mitered edge of side trim (see
Figure 24).
6. While firmly holding edges of trim together,
tighten both set screws on adjusting plate
with slotted screwdriver.
7. Repeat steps 2 through 6 or other corner.
8. Tighten trim hanging screws (#10 x 6.25
shoulder) into holes in cabinets. Place
the assembled trim onto fireplace cabinet.
OPTIONAL MANTEL INSTALLATION
Refer to instructions provided with the mantel
for assembly instructions.
INSTALLING OPTIONAL BLOWER
ACCESSORy GA3450TA
Refer to instructions provided with the blower
for assembly instructions.
Figure 24 - Assembling Trim
Top Trim
Mitered Edge
Side Trim
Slot
Shim
Adjusting
Plate
Set
Screws
Slot
Figure 25 - Attaching Trim to Fireplace
Assembled
Trim
Shoulder
Screw
Align hanging notches on trim with hang
-
ing screws on side of fireplace (see Figure
25). Push trim firmly into place, sliding
hanging notches over hanging screws.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor’s phone. Follow the
gas supplier’s instructions.
• If you cannot reach your gas supplier,
call the fire department.
C. Use only your hand to push in or turn
the gas control knob. Never use tools.
If the knob will not push in or turn by
hand, don’t try to repair it, call a quali
-
fied service technician or gas supplier.
Force or attempted repair may result in
a fire or explosion.
D. Do not use this appliance if any part
has been under water. Immediately call
a qualified service technician to inspect
the appliance and to replace any part of
the control system and any gas control
which has been under water.