13
103427
SPLIT OAK AND AMERICAN OAK DESIGN
18", 24" AND 30" MODELS
INSTALLATION
Continued
WARNING: Failure to posi-
tion the parts in accordance with
these diagrams or failure to use
only parts specifically approved
with this heater may result in
property damage or personal in-
jury.
INSTALLING LOGS (Split Oak
Design Models)
Bottom Middle Log (#2)
Metal Post
Metal Post
Peg
Groove
Groove
Grate
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install
these logs exactly as instructed. Do not
modify logs. Only use logs supplied with
heater.
1.
Place front logs (#1L and #1R) on top
of the grate. Make sure the notches in
the bottom of the logs fit over the grate
prongs (see Figure 22, page 12). Push
back of logs flush with metal grate bar.
Note:
18" model has only one front log.
2.
Rest bottom middle log (#2) behind
metal posts on front burner. Make sure
the grooves in the bottom of the log fit
over the grate. Bring the log forward
next to the metal posts. The pegs on
the log must be on top (see Figure 23).
3.
Slide the grooves in the back of the rear
log (#3) against the rear grate prongs.
Make sure the peg on the log is on top
(see Figure 24).
4.
Place the top middle log (#4) on the
bottom middle log (#2). Make sure the
pegs of the bottom middle log fit se-
curely in the holes of the top middle
log (see Figure 25).
Figure 23 - Installing Bottom Middle Log
(#2)
Rear Log (#3)
Peg
Grate
Prong
Grate
Prong
Rear
Burner
Groove in
Back of
Log
Groove
in Back
of Log
Figure 24 - Installing Rear Log (#3)
Top Middle Log (#4)
Hole
Peg
Peg
Bottom
Middle Log
Figure 25 - Installing Top Log (#4)
Hole
5.
Place the crossover log (#5) on the back
log and the top middle log. Make sure
the peg on the rear log is in the hole in
the bottom of the crossover log. The
crossover log should fit in the cutout
of the top middle log (see Figure 26).
Figure 26 - Installing Crossover Log (#5)
Crossover
Log (#4)
Hole
Peg
Cutout
