Edition:03/21_public
11
Manual Storage Heater
The heater must be prevented from tipping
over by fixing the two brackets to the wall
using the screws and plugs, all of which
are contained in the plastic bag in the
right-hand side of the heater cabinet. If
these screws and plugs are unfit for the
wall fabric in question, other suitable
materials must be used.
The connecting cables can now be drawn
through the strain relief at the back of the
heater and cut to length. Fix the safety
brackets to the wall at the height shown in
the diagram. Remember, when placing the
heater on thick-pile carpeting that the
heater will sink somewhat into the pile.
This must be allowed for as well as if the
heater is placed on a board or feet to raise
it from the carpet. The distance between
the brackets should be about one-half of
the heater length, although the exact
spacing is not important.
For more stability the brackets can be
screwed to the heater through the spacer
bracket at the rear of the heater.
Remove the metric screw at the right-hand
end of the air-outlet grille....