Deprag 420988 D, Operating Instruction Booklet

Page: 20 / 24

20
10 Troubleshooting
Please consult the operation instruction “Sequence Controller
AST10/AST11“ or “Sequence Controller AST(i)6“
Possible faults and their causes are shown below:
Fault Cause Solution
No power supply Check correct connection of the motor
cable.
Sequence controller not
switched on Switch the sequence controller on at the
main switch.
AST10/AST11

chapter Connections
an Pin Layout
AST(i)6

chapter Assembly Instruction
EC-
screwdriver
does not start
Controller displays error
message see Operating Instruction
AST10/AST11

chapter 10
Troubleshooting
AST(i)6

chapter Error Display and
Troubleshooting
If necessary, please send the tool to DEPRAG for service.
For further examples of faults please consult the instruction manual of the sequence
controller AST10, AST11 or sequence controller AST(i)6.
11 Shut Down and Storage
For shut-down perform the following steps:
No. Action
1.
Disconnect the electric equipment from power supply (switch off main switch and
pull out main plug).
2. Disconnect the screwdriver from the power supply.
3. Close all connections (with protection caps).
The screwdriver may now be stored until needed again.