5
Never exceed the rated voltage and power.
Never hold the drive, screwdriver tool or drive extension with your hands.
If you cannot support the reaction torque of the machine independently then use a
torque support (e.g. linear stand, telescopic arm, holding fixture/holder-on, support
grip).
It generally applies that:
In any case use a torque support to absorb the reac-
tion torque above: for straight screwdrivers 4 Nm; for pistol grip screwdrivers 10 Nm
and for angle nutrunners 60 Nm.
If it is not possible to use a torque support, use side handles for straight and pistol grip
screwdrivers. Side handles are recommended for straight screwdrivers at a torque set-
ting over 4 Nm and for pistol grip screwdrivers at torque settings over 10 Nm.
Use a finder/sleeve fitting where practicable.
When using sockets or adapters (e.g. magnet holder) make sure that they are in good
condition and suitable for use with this machine.
To prevent sockets breakage use only sockets (e.g. for impact or impulse screwdrivers)
which are suitable for use with this machine.
After turning off the tool, the screwdriver tool will continue to rotate (inertia).
