www.deponti.com Assembly Manual
– Verdeca Pergola page
24
7.2 Programming the motor
7.3 Resetting the motor
Step 1:
There isn’t a control unit box
on single motor products. Therefore, you are able to connect
this directly to an electric power unit (230V). Notice the motor will not respond to any transmitter
until it is assigned to communicate with the motor
’
s receiver.
Step 2:
Please select desired channel. To assign the transmitter to communicate with the motor's
receiver, push the “UP” and “DOWN” buttons on the transmitter SIMULTANEOUSLY,
the motor will
jog. The motor records the address of this transmitter, and only this activated transmitter will be
recorded into the memory of the motor.
Step 3:
Check the
direction of operation. The “UP” button must correspond to
closing the product. It
will stretch the ceiling cover of the pergola. If the direction is wrong, change the direction by pressing
“MY” b
utton until the motor jogs (3 seconds)
Step 4:
Stop the motor at the desired BACK limit. Align the last fabric support profile to the cross
beam.
Step 5:
To set the BACK limit, press the “MY” and “UP” buttons SIMULTANEOUSLY for more than 2
seconds. Release the buttons once the product begins to move towards front of the Pergola.
Step 6:
Press “MY” button and the motor will stop.
Step 7:
Press “MY” button CONSTANTLY until motor jogs to confirm the settings (5 seconds)
Step 8:
Finally, press the “PROGRAMING BUTTON” on the back of the transmitter until the motor
jogs to leave the installation mode.
NOTE: The f
ront limit doesn’t need to be set for single motor product as the motor will stop
automatically when fabric is stretch.
Step 1:
While provided power to motor unplug for 2 seconds
Step 2:
Plug in 10 seconds
Step 3:
Unplug 2 seconds
Step 4:
Plug in 10 seconds, the motor will jog briefly
Step 5:
Press and hold the PROG button on the back of Remote Control for more than 7 seconds until
the motor jog briefly 2 times. This removes ALL memorized motor transmitters.