Denzel 26915, User Manual, Page: 3 / 32

3
ANGLE GRINDER
EN
PROPER USAGE AND GENERAL INFORMATION
Angle grinder (hereinafter «machine», «tool») is designed to perform cutting, grinding, stripping operations with
metal structures or blanks using special abrasive discs and brushes. Subject to certain conditions an application
for processing of a stone, concrete, a brick is possible.
The tool is designed for usage at an environment temperature from 0 °С to 40 °С, relative humidity not more than
80% and absence of direct exposure of atmospheric condensation and excessive air dustiness.
The machine is suitable only for private use and must be used in intermittent duty not more than 20 hours
per month. It is recommended to use on-loading not more than a nominal, during 10-15 minutes and then
to have a break for 20-30 minutes. This usage mode enables to complete domestic tasks effectively and prevents
the tool from a premature coming out of order.
This manual contains the information and the requirements necessary and sufficient for a sure, effective
and secure use of the tool.
Due to ongoing activities in order to improve the tool the manufacture reserves the right to make minor changes
in its construction, not mentioned in this manual and not worsening its consumer and operational properties,
effective and secure use.
ACCESSORIES
Contents of delivery:
1.
Angle grinder 1
2. Side handle 1
3. Special key 1
4. Set of spare carbon brushes 1
5. Instruction manual 1
6. Warranty card 1
SPECIFICATIONS
Table 1
Parameter
Value
AG-230-2400 AG-230-2600
Maximum disc diameter, mm 230 230
No load speed, min
-1
6000 6000
Rated input power, W 2400 2600
Voltage, V 230 230
Frequency, Hz 50/60 50/60
Electronical speed control No No
Spindle thread М14 М14
Constant speed control No No
Soft start Yes Yes
Protection against accidental switch on Yes Yes
Lock on switch Yes Yes
Degree of protection against penetration of objects and liquids IP20 IP20
Sound pressure level (LpA), dB 93 98