Denzel 26915, User Manual, Page: 10 / 32

10
ANGLE GRINDER
EN
Adjusting of the position of the main handle (Model AG230-2400, Item 26915)
Depending on the type of tooling used and the nature of processing you can choose the optimal and most
convenient position of the main handle. To change the position of the handle, you must press the lock key 5
(pic. 1) and turn the handle relative to the case at 90 degrees clockwise or counterclockwise. When you release
the key 5, the handle locks in the selected position.
ATTENTION!
Always adjust the handle when the machine is unplugged.
Before using you must:
•
inspect and verify its completeness and no external damage;
•
make sure the power switch works correctly;
•
after transportation in winter conditions before turning on, leave at room temperature until complete drying
of water condensate.
Before getting started, you must:
•
set the handles and protective cover in a convenient for work position;
•
check the tightness of the threaded connection of fixing the tooling;
•
turn the spindle with a tooling by hand: his move must be free without jams;
•
try the machine at idle (also after replacing the grinding wheel);
•
make sure that the power switch is in the «off» position, then connect the machine to the mains.
To turn on the machine, press the switch key 7 (Fig. 1) by moving button 8 (Fig. 1) forward. If necessary, the power
switch key 7 can be locked in the «on» position, to do this with the key 7 pressed, move the lock button 8 forward
and the key will be locked. To turn off the machine, press and release key 7 again.
Recommendation: Try the switch key lock mechanism before connecting the machine to the mains.
ATTENTION!
The protective cover should always be installed during operation. Always use safety glasses.
While working:
•
after turning on the engine, let the machine develop the set speed of the tooling and only after that you enter
the tooling and the workpiece into contact.
•
always use the machine only for the types of work for which it is intended. When processing wood, use only
the designated tooling, safety of use of which on an angle grinder, no doubt.
ATTENTION!
Never use saw blades designed for circular saws on angle grinders. It is extremely dangerous!
•
do not allow mechanical damage, shock, falling of the tool on hard surfaces, etc.;
•
protect the machine from exposure to intense heat sources or chemically active substances, as well as from
the ingress of liquids and foreign solid objects inside the machine;
•
ensure effective removal of processing products from the cutting zone;
•
do not block or obstruct the ventilation openings in the machine case;
•
turn the machine off using the power switch before connecting / disconnecting power;
•
monitor the condition of the tooling and the heating of the electric motor;
•
do not allow pressing the spindle lock button 2 during operation - this will instantly lead to machine breakdown
and operator’s injury.