EN5
Note:
- Only sound can be heard when car is in motion.
- Refer and follow your country’s law regarding driving with video.
Caution:
- Do not attempt to install it by yourself if the instruction is not clear to you. Consult you dealer concerning the instal-
lation procedures.
DRIVING WITH VIDEO DISPLAY
By following the installation below, video will always be shown on LCD screen no matter the car is in motion or not.
INSTALLING REAR CAMERA FOR PARKING/REVERSE MOTION
You can install an separate camera at the car rear end so when doing parking or reverse motion, the unit will auto-
matically switch the video to the rear camera to guide the driver.
CONNECTOR A
4. 12V
5. AUTO ANTENNA OUTPUT
7. +12V (TO IGNITION KEY)
8. GROUND
NOTE: (connector A no. 7) must be connected by car ignition key in order to avoid that car battery becomes weak
when the car will be not used for long period.
CONNECTOR B
1. REAR RIGHT SPEAKER (+)
2. REAR RIGHT SPEAKER (-)
3. FRONT RIGHT SPEAKER (+)
4. FRONT RIGHT SPEAKER (-)
5. FRONT LEFT SPEAKER (+)
6. FRONT LEFT SPEAKER (-)
7. REAR LEFT SPEAKER (+)
8. REAR LEFT SPEAKER (-)
Maintenance
FUSE REPLACEMENT
If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after the replacement,
there may be an internal malfunction. In this case, consult your nearest repairing center.
Warning
Use the specified amperage fuse for each lead. Use of a higher amperage fuse may cause serious damage.
Steps: Connect the GRAY wire to the WHITE wire.
To rear camera video out
To reverse gear control switch
To Hand brake switch
ANTENNA
CONNECTOR
FRONT
REAR
AUDIO OUT
CAMERA IN
VIDEO IN
VIDEO OUT 1
VIDEO OUT 2
R
L
L
R
L
R
ISO CONNECTOR
B
A
1
2
3
4
5
6
7
8
4
5 7
8
REAR
OUT
CAMERA IN
VIDEO IN
R
L
L
R
Top view
Front side
Top view
Front side
Top view
Front side
To rear camera video out
To reverse gear control switch
To Hand brake switch
ANTENNA
CONNECTOR
FRONT
REAR
AUDIO OUT
CAMERA IN
VIDEO IN
VIDEO OUT 1
VIDEO OUT 2
R
L
L
R
L
R
ISO CONNECTOR
B
A
1
2
3
4
5
6
7
8
4
5 7
8
REAR
OUT
CAMERA IN
VIDEO IN
R
L
L
R
Top view
Front side
Top view
Front side
Top view
Front side
Steps:
1. Connect the Rear Camera IN plug to the rear camera’s video out plug.
2. Connect the RED wire to “REVERSE” gear control switch.
3. Check your gear control switch and make sure it is connected to +12V.
Steps:
1. Connect the gray wire to the hand brake system.
2. Check your hand brake switch and make sure it is connected to
car body chassis and properly grounded.
To rear camera video out
To reverse gear control switch
To Hand brake switch
ANTENNA
CONNECTOR
FRONT
REAR
AUDIO OUT
CAMERA IN
VIDEO IN
VIDEO OUT 1
VIDEO OUT 2
R
L
L
R
L
R
ISO CONNECTOR
B
A
1
2
3
4
5
6
7
8
4
5 7
8
REAR
OUT
CAMERA IN
VIDEO IN
R
L
L
R
Top view
Front side
Top view
Front side
Top view
Front side
B
1
3
5
7
2
4
6
8
5
7
4
8
A
