Dentsply Sirona
Operating Instructions Xios AE Sensor USB interface and sensors
4 Operation
4.5 Enable exposure readiness
67 29 433 D3780
D3780.201.01.01.02 09.2019
37
4.5.1.2
Repeating an exposure in the series
Performing an image retake — a feature also available in the
"Light Box"
— is available for any image in the current exam at any time. Most
commonly, this feature is used immediately after an image is acquired.
Some typical reasons for retaking an image would be the result of
unexpected patient or sensor movement, adjustment in X-ray settings,
or improvement in image placement or quality.
To retake an image, perform the following steps:
1.
Click on any image in the Acquisition view.
2.
Locate the Retake button below the
"Selected Image" window and
click on it.
3.
When the Retake image window is displayed, two exposure
windows —
"Current Image" and "New Image" — are shown.
4.
New Image is just like any empty exposure window selected for
imaging. It flashes red initially, as the sensor prepares for an
exposure, and flashes green when the sensor is ready.
5.
Take the X-ray exposure to acquire the new image.
6.
Compare and select the desired image and click on the
"Accept"
button. The rejected image is removed from the series, although it is
still present in the
"Timeline".
Ä
The selected image is used in the series.
7.
Perform other actions in Acquisition view, if any, then click the
"Finish" button to continue to the "Light Box"
