4.2 PERIODIC REGENERATION
Position 2 (DEPRESSURIZATION MODE
)
- Turn the valve handle on number 2. Loosen the cover handle and wait
until depressurization.
- Remove the lid and add the required quantity of salt according to the
model (1.0 kg)
Cleaning
Clean the lid and the seal from any salt residue.
Clean the upper part of the water softener from any salt residue and
clean both the tank and under the cover of the weld joint of any leaked
salt water.
The manufacturer does not take responsibility for the corrosion of the
tank caused by the failure to follow these instructions.
- Put the lid back on (pic. 1, G) and tighten the cover handle (pic. 1, F)
safely.
Position 3 (RINSING MODE)
- Turn the valve handle on number 3.
- Let the salt water come out from the drain pipe until the water is fresh
(around 40 minutes)
Position 4 (BACKWASH CLEANING MODE)
- Turn the valve handle on number 4 and wait for 30 seconds
(during the backwash mode, the water softener does not supply water)
Position 1 (SERVICE MODE)
- Put the valve handle back on number 1, service mode.
WARNING: during regeneration, the machine connected to the water
softener is supplied with non-softened water.
Summary of Contents for H8
Page 1: ...WATER SOFTENER mod H8 USER AND MAINTENANCE MANUAL ...
Page 10: ......
Page 12: ......
Page 13: ......