Denso QK20-R, User Manual

Page: 64 / 122

53
Code 39
Code data read will be transmitted as is.
You can select whether or not to transmit start and stop codes ("*").
Interleaved 2of5
The scanner transmits code data read, starting from the character following the start code to the one preceding the stop
code. No start/stop codes will be transmitted.
Codabar (NW-7)
The scanner transmits code data read including the start/stop codes. You can select whether or not to transmit
start/stop codes.
Code 128 (GS1-128 (EAN-128))
The scanner transmits code data read, starting from the character following the start code to the one preceding the
check digit. Start/stop codes, FNC codes, or check digit will not be transmitted. Note that FNC1 placed in character
positions other than the 1st and 2nd ones from the start code will be converted to GS (1Dh) and transferred.
The conversion to the GTIN format is also selectable. For the GTIN format conversion, refer to Section 9.5.
Code 93
The scanner transmits code data read, excluding start and stop codes and a check digit.
RSS (GS1 DataBar)
Code data read will be transmitted as is.
The conversion to the GTIN format is also selectable. For the GTIN format conversion, refer to Section 9.5.
RSS (GS1 DataBar) Composite symbols
Code data read will be transmitted as is.
Under the conditions "Code ID mark: Type 1" and "Code ID mark output mode: Separating," a separator (GS: 1Dh)
and 2D code ID mark are inserted between the linear component and 2D Composite component. (For details about the
code ID mark, refer to (5) Code ID mark on pages 43 to 48.)
Under the conditions "Code ID mark: Type 4" and "Linear component length (RSS/EAN-128): Variable," a separator
(GS: 1Dh) is inserted between the linear component and 2D Composite component.
UPC/EAN Composite symbols
Code data read will be transmitted as is.
You can select whether or not to transmit a check digit of the linear component (UPC/EAN).
Under the conditions "Code ID mark: Type 1" and "Code ID mark output mode: Separating," a separator (GS: 1Dh)
and 2D code ID mark are inserted between the linear component and 2D Composite component.
Under the conditions "Code ID mark: Type 2," the 2D code ID mark is inserted between the linear component and 2D
Composite component. (For details about the code ID mark, refer to (5) Code ID mark on pages 43 to 48.)