Denon S-102, Owner'S Manual

Page: 43 / 52

Get
ting Star
ted
Connections
Set
up
Pla
ybac
k
Remot
e Contr
ol
Inf
or
mation
If a problem should arise, first check the following:
1. Are the connections correct?
2. Is the set being operated as described in the owner
’ s manual?
3. Are the other components operating properly?
If this unit does not operate properly, check the items listed in the table below. Should the problem persist,
there may be a malfunction.
In this case, disconnect the power immediately and contact your store of purchase.
Troubleshooting
Symptom Cause Countermeasure Page
Display not lit
and sound not
produced when
power switch set
to on. • Power cord not plugged in
securely.
• Check the insertion of the power
cord plug.
10
Display lit but
sound not
produced. • Speaker cables not securely
connected.
• Device you want to play and set
input source do not match.
• Volume control set to minimum.
• MUTING is on.
• Digital signals not input Digital
input selected.
• Connect securely.
• Select an appropriate input
source.
• Turn volume up to suitable level.
• Switch off MUTING.
• Input digital signals or select
input terminal to which digital
signals are being input.
10
20
20
33
12
Monitor does not
display an image. • Connections between the video
output terminal of this unit
and the input connector of the
monitor are incomplete.
• The input setting of the monitor
TV is different.
• Check whether the connections
are correct.
• Set the input switching of the
TV to the terminal to which the
video input is connected.
11
12
When the
subwoofer
indicator has lit. • The subwoofer and main unit are
not properly connected with the
system cable.
• Check whether or not the cable
is properly connected.
If the indicator lights even though
the cable is properly connected,
there may be a malfunction.
10
G
General
H
Symptom Cause Countermeasure Page
Power turns off
suddenly and
power indicator
flashes red. • Protection circuit activated due
to rise of internal temperature.
• Core wires of two speakers are
touching each other or a core
wire is sticking out of the terminal
and touching the set’s rear panel,
activating the protection circuit.
• Set is damaged.
• Turn off the power, wait for the
set to fully cool down, then turn
the power back on.
• Place the set in a well-ventilated
place.
• First unplug the power cord,
then twist the core wires tightly
or terminate the speaker cables,
then reconnect.
• Turn off the power and contact a
DENON service center.
10
10
9, 10
–
G
Remote Control Unit
H
Symptom Cause Countermeasure Page
Set does not work
properly when
remote control
unit operated. • Batteries are worn.
• You are operating outside of the
specified range.
• Obstacle between main unit and
remote control unit.
• The batteries are not inserted in
the proper direction, as indicated
by the polarity marks in the
battery compartment.
• The set’s remote control sensor
is exposed to strong light (direct
sunlight, inverter type fluorescent
bulb light, etc.).
•
SOURCE CONTROL
switch position
is different.
• Replace with new batteries.
• Operate within the specified
range.
• Remove the obstacle.
• Insert the batteries in the
proper direction, following the
polarity marks in the battery
compartment.
• Move the set to a place in which
the remote control sensor will
not be exposed to strong light.
• Set the
SOURCE CONTROL
switch
for the device you wish to use.
5
5
5
5
5
8
Tr
oubleshooting
ENGLISH