Denon AVR-2313, Service Manual, Page: 37 / 230

37
4. Remote ID Setup mode
4.1. Specifications
When using multiple DENON AV receivers in the same room, make this setting so that only the desired AV receiver
operates.
4.2. Setting the AV receivers
Starting up:
Turn on the power, then press and hold down the "STATUS" and "DIMMER" buttons for over 3 seconds.
(1) When Remote ID Setup mode is started, the following is displayed.
FLD
R E M O T E I D ?
(2) Press the "QUICK SELECT 1 - 4" button that corresponds to the number you want to set.
Button FL Display
QUICK SELECT 1
R E M O T E I D 1
QUICK SELECT 2
R E M O T E I D 2
QUICK SELECT 3
R E M O T E I D 3
QUICK SELECT 4
R E M O T E I D 4
(3) Turn off the power using "Power operation (
X
)" button.
(4) Turn on the power using "Power operation (
X
)" button.
b
When Remote ID Setup mode is running, operations other than the "QUICK SELECT 1 - 4" buttons or "Power
operation (
X
)" buttons on the main unit are not received.
b
For the remote control that is supplied with this unit, you cannot change the REMOTE ID.
NOTE:
If the IDs do not match, "AVAMP
z
" (
z
is the main unit's remote control ID) appears on the display when the remote
control unit is operated.