Rev. 02/01/18 VER SMS-DYGP-PLUS-FREEFILL20170828-EN
11
Heat Insulator
Cut off the heat to avoid scalding the patient's
mouth.
Notice: Install it before injection and please to
avoid long term heat. Remove the insulator after
injection. Please fill out the charge and remove
heat protective sleeve.
Alternate use is recommended and avoid direct
contact with the human body.
Injection Needle
Used for injecting melted gutta-percha.
Notice
：
1.The needle can not be rotated
and twisted at will
2.Bend it by special tool as below
3.Loosen the nut when rotary motion needed
Tool
Fasten or loosen the nut,
bend the injection needle
Charging base
Place and charging the injection device
1)Use adapter as 7.5V 2.5A
2)After the adapter power is connected,
the charging lamp shows the red and
green alternately to indicate that the
battery is to be charged (not charged)
Rev. 02/01/18 VER SMS-DYGP-PLUS-FREEFILL20170828-EN
12
3)Place the injection device onto the charging base with the trigger inward
（
match well the charging electrode
）
,the charging lamp is red and bright
4)The power is full when the charging lamp is green.
Remarks
The charging base is not waterproof, the liquid contact electrode is
forbidden, and the conductor is forbidden to contact the charging
thimble.
A.
Heating pen/ FreeFill Obturation Pen
Heating pen
special equipment for cutting gutta-percha point and press the gutta-percha
vertically inside of the root canal
POWER
Extended press POWER for switching on/off, short press for shifting
temperatures(150
℃
、
180
℃
、
200
℃
、
220
℃
), it will switched off 5
minutes later without any operation.
Heating ON/OFF switch button
360°press button, heating starts when
press the button and stops when loose
the button, shows“
”during normal
operation.
