Denison Hydraulics Goldcup 6, Installation & Overhaul Instructions, Page: 18 / 24

SECTION V – ASSEMBLY PROCEDURES
BARREL HOLD-DOWN 1. Install seal ring (3) on hold-down shaft. Position bearing (2) between the two thrust
Figure 8 washers (1) and install around the seal ring.
2. Install hold-down nut (4) on the shaft and tighten no more than 10 ft. lbs. max. Back off
the nut until second slot is aligned with cotter pin hole in the shaft. Install cotter pin (5)
through nut and shaft and bend one tang over the end of the shaft.
3. Place O-ring (7) on end cover (6) and lubricate. Install end cover over hold-down nut
(4).
4. Depress cover and install snap ring (8). Make certain that snap ring is properly seated
in groove.
PARTS LIST FOR FIGURE 8
NO. QTY. PART NO. DESCRIPTION
1 2 350-10065 Thrust Washer
2 1 230-82131 Bearing NTA-1625
3 1 033-70510 Seal Ring
4 1 033-53922 Hold-down nut
5 1 322-03324 Cotter pin 3/32 x 1
6 1 033-70537 End cover
7 1 671-00138 O-ring
8 1 356-65095 Internal Snap Ring
17