Denison Hydraulics Goldcup 6, Installation & Overhaul Instructions, Page: 16 / 24

SECTION V – ASSEMBLY PROCEDURES
HOUSING ASSEMBLY
See Figure 5
1. Position housing (1) on a clean flat surface with the large open
end up.
2. Install bearing (2) in the housing bore. Insert pressing plug
tool (figure T-4) in the bearing. With a smooth and steady
force, press the bearing into the housing bore until seated.
DO NOT HAMMER OR BEAT INTO PLACE.
3. Turn housing (1) on side and install roll pin (4) in the 1/4”
through hole in the control cover pad. The pin must be
3/8” below the pad surface.
NOTE: The pin end must not interfere with the internal
bearing cage.
4. Install two dowel pins (3) in the blind holes in the same pad.
5. Repeat operation 3 on the opposite side of the housing.
6. Install O-ring (5) on plug (6) and install the hollow hex plug
in bottom of housing (1). Roll pins (4) are in bottom half
of housing.
HOUSING INSTALLATION
See Figure 6
1. Install the three face plate pins (1) in the holes provided in
the holes provided in the barrel face.
2. Apply heavy grease to the face of the barrel and install the
face plate (2) over the pins (1) in the barrel.
CAUTION: Make certain the plate is properly seated on
the barrel and pins.
3. Install gasket (3) over the two dowel pins (item 7, fig. 4) in the
mounting flange.
4. Install the housing assembly (4) over the barrel and auxiliary
shaft assembly and carefully guide the pressure tubes and
tube lines (items 3, 4 and 5, fig. 4) through the housing
assembly (4, fig. 6).
PARTS LIST FOR FIGURE 6
NO. QTY.
PART NO. DESCRIPTION
1 3 033-49825 Face Plate Pins
2 1 033-71530 Barrel Face Plate 6 in.3 only
1 033-72532 Barrel Face Plate 7.25 in.3 only
3 1 033-70576 Housing Gasket
4 1 See Fig. 4 Housing Assembly
15