DENGENSHA WS-100, Instruction Manual

Page: 26 / 39

19
DENGENSHA
(1) Measurement mode (Detail of mode)
There are four measurement mode.
・
Pulse mode [Pulse]
・
Multi mode
：
[Multi]
・
Seam mode
：
[Seam]
・
Continuous mode
：
[Cont]
(a) Pulse mode
 Maximum measurement time is 99 cycles including pulse and cool time, and up to 50
pulses are available as one weld.
 When measured cool time is longer than [Sep cool]setting, next pulse is considered as
next weld.
When measured cool time is shorter than [Sep cool]setting, next pulse is considered
as present weld.
 Only welding time of specified pulse [p1 ~ p50] is displayed and storage as welding
time. (display item
②
)
In case of measuring one pulse weld, please set [p1].
In case of measuring pulsation welding, please specify target pulse number to be
displayed and storage.
 Setting of [First] &[Last]
Only average welding current of specified pulse [p1 ~ p50] is displayed as average
welding current. (display item
①
)
WS-100 also starts calculating average welding current from [First] setting cycle of
specified pulse.
And also completes calculating average welding current at [Last] setting cycle of
specified pulse.
When pulse finishes before [Last] setting cycle, WS-100 completes calculating
average welding current at that time.
After measurement, it is possible to display average weld current and time of
another pulse by changing setting of [Pulse],[First] and [Last] while measurement
data is stored in memory.
p1 p2 to p50 p1 p2 to p50
Measuring weld next weld
Cool to 99cyc
to 99cyc