Final Set-Up
Page of
5
7
Bottleless,com. xowater.com
© 2018 XO Water, LLC. All rights reserved.
Attach front panel
Place bottom of front panel
into the base. Then, push
down on top so that it can
fit into place.
Attach drip tray
Push drip tray back into
place.
Fill hot tank
a) Press the red button on
the front of hot faucet
b) Press the cup against the
“paddle” portion of the hot
faucet and hold.
Turn on hot switch
On back of cooler, turn on
red hot switch.
TIP
: If you
do not want hot water to be
dispensed from your cooler,
leave this switch o
ff
.
Put external lid
back on cooler
Press in on the back of the
top lid and replace on
cooler. You do not need to
replace the 2 screws.
Press reset button
Press reset button one more
time to be sure that the
safety float hasn't been
tripped.
Plug into outlet
Plug cooler into standard 3-
prong electrical outlet. You
do not need to wait for the
cooler to fill completely (as
long as water was dispensed
from the hot faucet).
Check Hot Water
Press the safety button on
the front of the hot faucet.
Then, push a cup/mug in
against the hot faucet
“paddle” to make sure the
cooler is heating your
water. Enjoy!
Check cold water
It will take about 30 minutes
or so for the cooler to heat
and chill your water. After
about a half hour, take a
drink of cold water. Enjoy!
If you need to adjust
cold temp:
Adjust the temperature of
cold water by rotating the
thermostat control located
on back of the cooler. Use a
“flat-head” screwdriver.
Clockwise is colder.
Hold until water
comes out of hot
faucet
Hold cup to hot faucet until
water comes out (may take
3+ minutes). Release and let
cooler fill.
Water must come
out of faucet BEFORE
turning on hot switch.
If you need to empty
water from cooler:
Unplug cooler from electrical
outlet & let the hot water cool
down for an hour+. Then,
remove drain plug on back by
unscrewing cap. Let water
flow into bucket or trash can.
Be careful - water may be
hot.
Push
Safety
Button
Cold
Water
thermostat
Drain
Plug
1
2
1
2
