Installing the filter Inside: Part 1
Page of
3
7
Bottleless,com. xowater.com
© 2018 XO Water, LLC. All rights reserved.
Remove drip tray
Lift up on drip tray to
remove. It just pulls straight
up from the cooler.
2) Pull front panel
towards you
Pull top part slightly away
from the cooler.
3) Lift Front Panel up
Lift it up and out. Once you
clear the tab in the previous
step, it should lift straight up.
Set aside
remove filter
bracket screws
Using a Phillips-head
screwdriver (photo shows
an electric screwdriver),
remove the 4 screws that
attach the filter bracket to
the cooler.
Re-attach filter
bracket at top
The commercial filters that
come with your Denali are
too tall to be attached at the
lower position. Re-attach
filter bracket at the higher
location.
Locate waterway TO
cooler
Inside of the cooler, locate
waterway inside the cooler
that goes to the cooler's
reservoir.
Make sure internal
waterway is above
filter bracket
Reach in the cooler and
move the waterway above
the filter bracket so that it
easily attaches to the filter
head.
Push waterway
FROM source through
back of cooler.
Push the waterway that
comes from the water
source (not the one already
in the cooler) through the
back of the cooler.
Pull source
waterway through
Pull the waterway that
comes from the water
source through the hole so
that you have enough length
to reach the filter head.
Remove bracket
from filter head
Pull the filter head bracket
o
ff
of the filter head. This
will be mounted upside
down onto the filter bracket
that is inside the cooler
Attach head bracket
to filter bracket
with a zip tie
Position the filter head
bracket upside down and
behind the filter bracket. Pull
the zip tie through the hole in
the head bracket and around
the filter bracket.
Remove Front Panel:
1) Press down on top
of front panel
First, press down on front
panel firmly to get the top
tab
Filter
Bracket
Water
Line
To
Cooler
-Drip
Tray
1
2
3
