2. Wiring The Display
DENALIELECTRONICS.COM
2.1 - Connecting The B6 Brake Light
Step One:
Route the brake light harness (f) up through the wire pass
through on the display base (a). Cut the spade terminals off the end of the
wiring harness (f) and use the Posi-Lock connectors that came with the B6
Brake light to attach the harness to the B6.
2.2 - Connecting The Switch
Step One:
Connect the smaller female spades to the male spades on the
bottom of the switch (g).
12v DC Power (Output)
12v DC Power (Input)
(f)
To Switch (g)
To B6 Brake Light
Cut and Remove Spade Connectors.
Instead use Posi-Locks from B6
2.3 - Connecting The Light Pods
Step One:
Pass the pod connectors and cables through the square holes
behind the pods. Then connect each pod to its mating connector on the
Display Wiring Harness (b).
2.4 - Connecting The Switch
Step One:
Pass the switch connector and cable through the large hole in
front of the switch. Then connect the switch to its mating connector on the
Display Wiring Harness (b).
Step Two:
Once all connections have been made, use the included zip ties
(n) and adhesive zip tie anchor (m) to neatly conceal the wiring to the
underside of the sheet metal display base (a).
Switch (4-Pin)
Light Pod Two (3-Pin)
12v DC Power (Input)
12v DC Power (Output)
Light Pod One (3-Pin)
(b)
