Rev. A, January 2021
Bone-Cutter Operator’s Manual
4
3
General Product Data
The DEMTECH Services, Inc. Bone-Cutter Test Coupon Cutter, hereinafter referred to as the Bone-
Cutter or Cutter makes for a very efficient post weld testing process. The Bone-Cutter has been
designed to withstand the wear and tear of a jobsite as well as provide the user with an easy-to-use
reliable coupon cutter. A quick release retractable base and handle make packing and unpacking quick
and easy. A lightweight durable cover helps prevent injury and a 10 sample chamber allows for
efficient high volume testing.
4
Unpacking and Set-Up
4.1
Unpacking
Before opening the shipping/storage case for the first time and unpacking the Bone-Cutter,
inspect the outside of the case thoroughly for any signs of mishandling or damage during
shipping. Report any damage to the shipping carrier immediately and
do not proceed with
unpacking
. You should consult your administration concerning claims for shipping damage.
Please notify DEMTECH Services, Inc. or your authorized DEMTECH distributor where the
product was purchased in the event of any shipping damage.
Unlatch and open the shipping/storage case lid and inspect inside the case and equipment
thoroughly for any signs of mishandling or damage during shipping. Report any damage to
the shipping carrier immediately and
do not proceed with unpacking
. You should consult
your administration concerning claims for shipping damage. Please notify DEMTECH
Services, Inc. or your authorized DEMTECH distributor where the product was purchased in
the event of any shipping damage.
The Bone-Cutter Test Coupon Cutter is delivered to you in a sturdy, reusable
shipping/storage case. The custom foam insert protects the unit from damage during
shipping and should be stored in the case at all times when not in use. When the unit is
out of the case, make sure the lid is closed to avoid dirt, dust and rain from getting inside.
Once the Bone-Cutter has been removed from the case, it is ready for use except for any
necessary set-up adjustments. For set-up procedure, refer to the set-up adjustment section in
this manual.
Make note of the orientation of the equipment and packing foam inserts inside the shipping
case to facilitate any repackaging requirements in the future. To avoid injury and/or damage
to the cutter, be sure to use adequate care when lifting, removing or replacing the welder into
the shipping/storage case. The cutter must be removed from the shipping/storage case and
placed in an appropriate location suitable for the cutting you intend to perform.
