RD20024
Page 13
7. Push wires back into housing and finish routing wires in wire trough of fender
and attach cable hanger. Install two metal wire clips using pliers. Place one clip
5-1/2” from rear of fender and one 8” from rear of fender (see red arrow).
8. Install rubber grommet and attach 3 wire pigtrail harness (#15975) to fender wiring (bullet
connectors).
NOTE: On the left side, plug in the bullet plugs with white to white, brown to
black and yellow to red. On the right side, plug in bullet plugs with white to white, brown to
black and green to red.
9. The front marker light male bullet connectors will plug into remaining female ports on
the pigtail harness. Black to black and white to white. Coil pigtail harness inside of
fender housing and plug into 4” round light. Push light into grommet until seated firmly
into grommet.
Fender Assembly Instructions
