Page 12
RD20024
1. Cut nylon wire tie from wiring attached to fender mount
on mainframe (used for shipping purposes only)
2. Install fender with fender back-up plate and three 3/8” x
1-1/2” bolts. Put 3/8” nylon lock nuts inside of fender and
tighten.
3. Mount the mud flaps to the inside back of the fender
using two 1/4” x 3/4” truss head stainless steel bolts
(10732) with flat washers and nylon lock nuts. Make
sure the Kar Kaddy logo on the flap faces the rear.
4. Fish the three wires from the mainframe through the rear
hole in the fender trough.
5. Route wiring in through back of tail light housing on the
bottom inside of housing. Fish the three wire inside of
housing. The front marker light wires lay in the trough
and route wires through back of tail light housing with
main frame wires (see red arrow).
6. Pull all wire from light hole in housing and install the
snapper hose clip approximately 1-1/2” back from end of
wire shielding. Squeeze snapper clip tight with pliers.
Fender Assembly Instructions
