![background image](http://html1.mh-extra.com/html/deluxe-stitcher/m19-series/m19-series_operation-and-maintenance-manual_2479472016.webp)
15
The Work Stops, which are included with all M19 Stitchers, ensure consistent placement of
stitche
s time after time. Both types of Stops available perform a different and specific function.
Use the Work Guide, set of Work Stops, or both depending on the application at hand.
Work Guide
The Work Guide (M7201B), sometimes referred to as the Back Guide, is controlled by two (2) Work
Guide Screws (63). The slots in the rear of the Guide allows free placement of the Stop. Slide the
Work Guide back and forth until the the location on the stock being stitched is under the Driver. Once
the ideal location is determined, the two (2) Work Guide Screws are tightened and the Guide is locked
into place. Two (2) Table Extender Brackets (7659) are attached to the Work Table Assembly (7656A)
for additional Work Guide placement. To use these extensions, loosen and remove the two (2) Work
Guide Screws and insert them in the Extender Brackets. Slide the Work Guide back and forth until
the proper stop location is found and tighten the Screws as before.
Work Stops
The two (2) Work Stops (7423), sometimes referred to as the Side Guides, are controlled by two (2)
Thumb Screws (425). Slide each of the two (2) Work Stops along the Work Guide until the desired
location on the stock being stitched is under the Driver. Once the perfect position is found, tighten
each of the two (2) Thumb Screws.
Adjusting the Work Stops (Figure 9)
Summary of Contents for M19 Series
