Deltafox DG-ESS 2844, Translation Of The Original Instructions For Use

Page: 27 / 128

27
GB
• Do not unplug the shredder
by the cable. Keep the cable
away from heat, oil and sharp
edges.
Installation manual
Unpacking
1. Remove the shredder from the
packaging.
2. Make sure that the on/off
switch ( 6) is set to the posi-
tion “
O ”.
Assembling the shredder
1. Screw the two wheels (13) to
the chassis (14) with the in-
cluded mounting material in the
order shown. Insert the Allen
key (20), included in the scope
of delivery, into the hole on the
axis (21) to hold in place and
prevent it from turning as well.
A suitable spanner (22) is also
enclosed.
2. Clip the covering caps (19) into
the wheels (13).
3. Make sure that the on/off
switch (6) is set to the position
“
O ”.
4. Insert the chassis (14) into the
threaded rods integrated in the
housing (5). Attach the nuts
provided and tighten firmly.
Operation
Switching the shredder on and off
Make sure that the mains power
voltage agrees with the type plate
on the shredder.
1. Make a loop at the end of the
extension cable and hang the
loop onto the strain relief (16)
on the mains cable (17).
2. Suspend the collection bag (11)
by the handles from the col-
lection bag fixing points (9) on
both sides of the housing (5)
3. Connect the extension cable.
4. Make sure that the funnel feed-
er ( 3) is empty.
5. Move the direction switch (1) to
position “I” (forwards).
6. To start, now press the on/off
switch (6), button “
I
”.
The operating mode selection
switch locks into place.
7. Place your chopping material in
the fill hopper ( 3). The mate-
rial is drawn in and chopped.
8. To switch off, press the “
O
”
button on the on/off switch (6).
The shredder will continue to run
immediately after switching off.
Changing the rotation direction
The rotation direction can be changed.
1. Switch the device off and wait
for it to come to a standstill.
2. Move the direction switch (1) to
position “II” (reverse).
3. To start reverse, press and hold
the “ I ” button on the on/off
switch (6). The device is now in
inching mode.
The jammed chopped materials are freed.
4. To continue chopping, release
the “I” button on the on/off
switch (6). Wait until the appli-
ance has stopped.