NovoDisplay User Manual
Copyright © 2019 Vivitek. Vivitek is a trademark of Delta Electronics, Inc.
24
To mount NovoDisplay onto a wall follow the instructions below:
1. Place the four (A) POM nuts over the wall mount screw holes on the rear side of the
display.
NOTE: If there are any screws or covers installed into the wall mount screw holes, remove
them before placing the POM nuts over the screw holes.
2. Install the four (B) 5x43mm screws into the (A) POM nuts to secure them on the
display. Measure and record the distance Y between the top two POM nuts.
3. Place the two (C) U-shaped mount brackets in the correct position on the wall where
you want mount the display on ensuring that the distance between the mount
brackets are the same as the Y distance measured in step 2.
CAUTION: Use a levelling tool to ensure that the mount brackets are installed perfectly
horizontal and vertical. If not the weight of the display will not be evenly distributed between
the mount brackets which may cause the mount brackets to fall off.
4. Install the eight (D) 6x50mm screws into the mount brackets to secure them in place.
NOTE: If necessary, drill holes in the wall to ensure that the screws can be firmly secured to
the wall.
