![background image](http://html1.mh-extra.com/html/delta/dpm-c530a/dpm-c530a_user-manual_2472681020.webp)
19
(7) Setup for backlight brightness, method of wiring
、
CT
數、
PT
數
and phase sequence reversal all
follow the steps mentioned above.
(8) Select Timeout and press the Enter key to start setting up for timeout.
(9) When the option is highlighted, start setting up by using the Up and Down keys to select the
numbers needed.
(10)
Press the Enter key to finish setting up for a number and move on to set up for the next number.
(11)
Repeat steps (9)~(10) until finishing setup for the last number and press the Enter key. When the
highlight disappears, setup is complete. If there is a need to cancel the setup in the middle, press
the Menu key to return without saving the numbers that were just set.
(12) After completing or cancelling the setup, press the Menu key again to return to the setup menu
6.3.5 Alarm Settings
■
Alarm:
Whether this alarm is enabled or disabled (factory default).
■
Upper:
When the threshold set on the meter is exceeded, an alarm will be generated. The factory default is 0.
■
Timeout:
When the threshold set on the meter is exceeded and the time delay set is overdue, an alarm will be
generated. The factory default is 0.
■
Lower:
When the threshold set on the meter falls short, the alarm will be cancelled. The factory default is 0.
■
Timeout:
When the threshold set on the meter falls short and the time delay set is overdue, the alarm will be
cancelled. The factory default is 0.
■
Steps to set up are as follows:
(1) Press Menu key until the menu appears.
(2) Select 0. Setup and press Enter key to enter into the setup menu.
(3) Select 6. Alarm and press the Enter key to enter into options.
(4) Select the setup item needed and press the Enter key to enter into the option.
(5) Select Alarm and press the Enter key to start setting up.
(6) When the option is highlighted, start setting up by using the Up and Down keys to select the mode
needed.
(7) Press the Enter key to complete. When the highlight disappears, setup is complete. If there is a
need to cancel the setup in the middle, press the Menu key to return without saving the mode that
was just selected.
(8) Select Upper and press the Enter key to start setting up for timeout.
(9) When the option is highlighted, start setting up by using the Up and Down keys to select the
numbers needed.