Delta 21CK018C24, Instruction Manual

Page: 45 / 64

44
The specs of the selected join drain hose should fits the running capacity of the unit.
.
Above100mm
T-tie in join drain hose
☆
Check the smoothness of drain after installation.
☆ Check the drain state by immitting 600cc water slowly from the outlet vent or test hole.
☆ Check the drain in the state of refrigerating after installation of the electric circuit.
[
Way of immiting
]
.
Drain hose
Test hole cover
Test hole
Above100mm
Drain vent for repair use (plastic
stopper is included) (drain the water
in waterspout by this outlet vent)
<
Immiting water from the outlet
vent terminal
>
Plastic water pot (The length of the
pipe should be about 100mm.)
<
Immiting water from the rest hole
>
●
Warning:
Before obtaining access to terminals, all supply circuits must be disconnected.
12.2 Electric wiring
1
、
All field supplied parts and materials must conform to local laws and regulations.
2
、
For electric wiring, refer to WIRING DIAGRAM attached to the unit body.
3
、
All wiring must be performed by a skilled technician.
4
、
A circuit breaker capable of shutting down power supply to the entire system and which have at
least 3 mm contact separation in each jole must be install in the fixed wiring.
5
、
Earth properly.
6
、
Wiring must conform to national laws and regulations.
7
、
The fixed wiring must be installed with a protector with no more that 30 mA leakage current.
8
、
If the supply cord is damaged, it must be replaced by the manufactory or its service agents or a
similarty qualified person in order to avoid a hazard.