EN
4
5
Recommendations
- Correct operation of the motor is ensured if it is installed and used
according to the following recommendations.
The peripheral elements such as the roller tube, supports, fastenings,
etc. must be chosen correctly and assembled in compliance with
good practice. Furthermore, the motor operating environment and
power required are elements that must be carefully chosen and
assessed. The characteristics of the driven part must be compatible
with the rated load and operating time.
- A-weighted sound pressure level: LpA ≤ 70 dB(A).
- Cables going through a metal wall must be protected and isolated by
a sleeve.
The TYMOOV xRP2/DxRP2 or xRE2 cable can be disassembled.
- If the power cable is damaged, it must be replaced by the
manufacturer, after-sales service or similarly qualified personnel in
order to prevent hazards.
- The motor must be chosen according to the requirements of the load
bearing support. See our charts for selecting the motor according to
the shutter type. A plate on the motor indicates the nominal torque
and operating time.
- TYMOOV xRP2/DxRP2 or xRE2 tubular motors are designed to
operate intermittently (4 minutes of continuous operation). They
are electronically protected to prevent overheating. If there is a
thermal shutdown, the motor will operate again after a time period
of approximately 30 seconds. To operate again for 4 minutes, the
motor must have returned to room temperature.
- If an attempt is made to raise the shutter (for example: intruder test),
the motor will lower the apron. Caution, your fingers may be caught.
DELTA DORE hereby declares that the motorised systems covered by these
instructions comply with the essential requirements set out by the Machinery
Directive 2006/42/EC and the European directive RED 2014/53/EU.
The EU declaration for this equipment is available on request
from:
Service “Info techniques”
DELTA DORE – 35270 Bonnemain (France)
email: [email protected]
DELTA DORE
35270 - BONNEMAIN - France
Because of changes in standards and equipment, the characteristics given in the text and the illustrations in this
document are not binding unless confirmed by our departments.