36
STEP 11
PASO 11
Parts and tools required to complete step
Piezas y herramientas necesarias para completar este paso
Phillips Screwdriver – Not included
Destornillidor Phillips – no incluido
No drills necessary.
Do not use power screwdriver.
No hace falta taladrar.
No utilice destornilladores eléctricos
Install the Drawer Support (Part T) and
Drawer Back (Part S), using (2)
Φ
6x30mm Dowels (Pièce KK), (5) 40mm
Screws (Part HH) and (5) Plastic Barrel
Nuts (Part LL). Note: Grooves In Bottom
Must Align. Tighten With Phillips Screw-
driver. Repeat this step until 6 drawers
are complete.
Instale el soporte de gaveta (Pieza T) y
Trasera de la gaveta
(Pieza S) utilizando
(2) Pasadors
Φ
6x30mm (Pieza KK), (5)
tornillos de 40 mm (Pieza HH) y (5) tuercas
cilíndricas plásticas (Pieza LL). Nota: Las
ranuras al inferior deben alinearse. Apriete
utilizando un destornillador Phillips. Repita
este paso hasta haber completado las 6
gavetas.
HH
KK
LL
Φ
6x30mm Dowel x12
Pasador
Φ
6x30mm
40mm Screw x30
Tornillo 40mm
Plastic Barrel Nut x30
Tuercacilíndricaplástica