5
Frost prevention mode (anti-freeze setting)
You can keep the room at a temperature of about 41°F (5°C) to prevent freezing with minimum
energy consumption.
Press the
MODE
button (
F
) until
AUTO
is displayed. Press the button (
E
) to select a temperature
set point of 41°F (5°C). When the room temperature drops below the set temperature, the
appliance comes on automatically.
USING THE REMOTE CONTROL
The remote control should be handled with care.
1. Press the ON/OFF button (
G
).
2. To use the swing (
C
), SET TIME (
D
), MODE (
F
) and temperature adjustment (
E
) buttons, see
the FUNCTIONING AND USE section.
3. To replace the batteries, remove the cover on the back of the remote control unit.
The remote control uses two AAA type alkaline batteries (included but packaged separa-
tely).
4. Do not mix used and new batteries with different values.
MAINTENANCE
-
Always unplug the heater before cleaning.
- During the season when the appliance is in use, clean the air intake and exhaust grilles
regularly using a vacuum cleaner.
-
Never use abrasive powders or solvents.
SAFETY ALARM
The appliance emits an acoustic alarm signal in the event of overheating. If the safety alarm
trips, turn the appliance off and eliminate the cause of overheating.
DO NOT USE THE APPLIANCE WHEN THE ALARM HAS TRIPPED.
SAFETY DEVICE
A
safety device
shuts the heater down in the event of accidental overheating (the red CAU-
TION
light comes on).
To reset, unplug the appliance for a few minutes, remove the cause of
overheating (i.e. any obstruction of air intake and exhaust grilles) then plug it in again. If your
appliance still does not function normally, contact your nearest service center.
The appliance is equipped with a anti tip-over safety device
This device turns the heater off should it tip over or become unstable. To start the appliance up
again, simply put back in a vertical position.
