8
Figure 5
ANTI-TILT BRACKET
Important!
To restrain the appliance and prevent it tipping accidentally, the anti-tilt
bracket must be fitted according to the instructions below.
1. Drill four 8mm diameter holes for the fixing screws (two in the wall and two in the
floor - see Fig. 5) and insert the plastic plugs supplied.
Important! Before drilling the holes, check that you will not damage any
pipes or electrical wires.
2. Attach the anti-tilt bracket to the floor and rear wall using the four screws supplied,
as shown in Fig. 5.
3. After attaching the anti-tilt bracket securely, slide the cooker close to the anti-tilt
bracket and vertically fit the rear right foot into the circular opening of the bracket by
lifting the rear of the cooker. Then slide cooker into place.
Ensure that the rear right foot slides under the bracket, as shown in Fig. 5.
=
=
260
Dotted line showing the position
of the cooker when installed
Foot of cooker
Anti-tilt
bracket
Attaching the anti-tilt bracket and sliding the cooker into place
IMPORTANT NOTE: if necessary adjust the height of the feet to ensure the rear
right foot slides under the anti-tilt bracket.
Summary of Contents for DEF605GW
Page 36: ...cod 1103185 ß1 ...
