26
Description of the remote control
REMOTE CONTROL
Inserting the batteries
•
Slide the cover as shown in figure.
•
Insert two new non-rechargeable batte-
ries, being careful to place them in the
correct positions (+) and (-).
•
Put the cover back on, letting it slide into its
original position.
•
The Display will show all of the remote con-
trol's symbols for several seconds.
At this point the clock on the display will start
to blink showing 12:00 o'clock; at this point
set the correct time.
Note: WE SUGGEST USING ALKALINE BATTE-
RIES.
If the remote control is to be replaced or
thrown away, the batteries must be remo-
ved and disposed of in accordance with
the current laws as it represents an environ-
mental hazard.
SETTING THE CLOCK
•
If the time is not set within two minutes of
the reset or of battery replacement, the
remote control will automatically read
12:00.
•
To programme the hour, push the
keys to move ahead or back. The seg-
ments are of one minute.
If you hold the buttons down, the minute
designations will run more quickly.
•
The clock will continue to blink. Push the
SET button to confirm the time set: the
clock will then stop blinking.
•
If you have to adjust the time, you must
push the RESET button and then enter the
correct time. (There is no other way to do
this).
PROPER USE
•
Point the remote control toward the air-
conditioner’s signal receiver
.
•
Maximum distance: about seven (7)
metres (without any obstacle between
remote control and receiver).
•
The remote control must be handled with
great care
: do not drop it, expose it to
direct sunlight, or leave it close to heat
sources.
10
MODE
MODE
FX180eco 16-05-2002 14:53 Pagina 26
