DeLonghi PAC ES, Instruction Manual

Page: 13 / 123

12
INTRODUCTION
Thank you for choosing this De’Longhi product. Please take a few
minutes to read these instructions. This will prevent running any
risks or damaging the appliance.
DESCRIPTION
Description of the appliance (see page 2 - A)
A1 Air outlet grille
A2 Control panel
A3 Handles
A4
Wheels
A5
Rear filter
A6 Side filter
A7 Air intake grille
A8 Air exhaust hose housing
A9
Air intake grille
A10
Power supply cable
A11 Upper drain connection with cap
A12 Lower drain connection with cap
A13 Remote control compartment
Description of accessories (See page 2 - B
)
B1 Air exhaust hose
B2 Hose adapter
B3 Adapter for wall mounting /window
B4
Adapter for window
B5
Wall flange with cap
B6 Remote control
ELECTRICAL CONNECTION
Before plugging into the mains, check the following:
• the mains voltage is the same as that indicated on the plate
on the back of the appliance;
• the socket and electrical line are sized to support the load
required;
• the socket is the proper type for the plug, otherwise, re-
place the socket;
• the socket is connected to an efficient earthing system. The
manufacturer is not responsible in the event of non-com-
pliance with these injury prevention standards.
•
The power cable must only be replaced by special-
ised technicians.
USE
The instructions below will enable you to prepare your air con-
ditioner for operation as efficiently as possible. Before use, make
sure the air intake and outlet grilles are unobstructed.
Maintain a minimum distance of 60 cm from walls and obstacles
(Fig. 3).
In conditioning and dehumidification the air exhaust hose (B1)
must be applied (Fig. 1).
Please note: This appliance is provided with an auto-evapora-
tion feature for condensate removal during cooling and dehu-
midifying mode.
AIR CONDITIONING WITHOUT INSTALLATION
CASEMENT WINDOW
If you have a casement window proceed as follows:
• Fit the air exhaust hose (B1) in the relevant housing located
on the rear side of the appliance (Fig. 1).
• Position the air exhaust hose (B1) with the window adapter
(B4) outside the window to let the hot air out (Fig. 2).
AIR CONDITIONING WITH INSTALLATION
If desired, the appliance can also be installed in a semi-perma-
nent manner.
In this case, it is necessary to:
• Drill a hole (diam. 150 mm) in a perimeter wall, or through
the glass of a window. Respect the height and dimensions
of the hole indicated in the figure shown below.
150
MAX 100 cm
MIN 35 cm
• Apply the supplied flange accessory B5 in the hole.
• Position the air exhaust pipe ( B1 ) in the dedicated seat at
the rear of the appliance (fig. 1).
• Attach the end of the pipe
B1
to the flange
B5
as shown in
fig. 9.
Limit the length and bends in the air pipe as much as pos-
sible, avoiding any bottlenecks.
in the glass
of the
window
in the wooden
base of the
French window
in the wall