28
DISPLAYED MESSAGE
POSSIBLE CAUSE
REMEDY
NOT ENOUGH COFFEE.
CONSULT MANUAL OR
CUSTOMER SERVICES
The beans present sensor is dirty and not work-
ing correctly
Remove the dust from the sensors using a cot-
ton bud.
If the problem persists, contact De'Longhi Cus-
tomer Services.
GROUND TOO FINE. ADJUST MILL
USING THE DEDICATED FUNCTION
IN MACHINE SETTINGS
The grinding is too fine and the coffee is deliv-
ered too slowly or not at all.
Adjust the coffee mill (see “6.4 Adjust mill”).
If the water softener filter (C6) is present, an
air bubble may have been released inside the
circuit, obstructing delivery.
Insert the hot water/steam spout (F) in the ap-
pliance and deliver a little water until the flow
becomes regular. If the problem continues, re-
move the filter (see section “20.3 Removing the
filter”)
SELECT A MILDER TASTE
OR REDUCE PRE-GROUND
COFFEE QUANTITY
Too much coffee has been used.
Select a milder "Aroma" (see “7.3 Customising
the beverages”) or reduce the quantity of pre-
ground coffee (maximum 1 measure). Press
"OK to go back to the homepage or wait until
the message disappears.
INSERT WATER SPOUT
The hot water spout (F) is not inserted or is
inserted incorrectly.
Insert the hot water spout and push as far as it
will go (fig. 7): the appliance beeps (if the beep
function is enabled).
INSERT MILK CONTAINER
The milk container (D) is not inserted correctly. Insert the milk container and push as far as it
will go (fig. 22): the machine emits a beep (if
the beep function is enabled).
