20
15. DISPLAYED MESSAGES
DISPLAYED MESSAGE
POSSIBLE CAUSE
SOLUTION
FILL TANK
Insufficient water in the tank (A7).
Fill the tank with water and/or insert it cor-
rectly, pushing it as far as it will go until it
clicks into place.
EMPTY GROUNDS CONTAINER The grounds container (A18) is full.
Empty the grounds container and drip tray
(A16), clean and replace (fig. 28). Important:
when removing the drip tray, the grounds con-
tainer must be emptied, even if it contains few
grounds. If this is not done, when you make the
next coffees, the grounds container may fill up
more than expected and clog the machine.
GROUND TOO FINE ADJUST
MILL
The grinding is too fine and the coffee is deli-
vered too slowly or not at all.
Repeat coffee delivery and turn the grin-
ding adjustment dial (A6) (fig. 13) one click
clockwise towards 7 while the coffee mill is
in operation. If after making at least 2 coffees
delivery is still too slow, repeat the correction
procedure, turning the grinding adjustment
dial another click until delivery is correct (see
section:”7.4 Adjusting the coffee mill”).
If the water softener filter (C4) is present, an
air bubble may have been released inside the
circuit, obstructing delivery.
Insert the hot water spout (C6) in the appliance
and deliver a little water until the flow beco-
mes regular.
→
9. “Water delivery Press OK” is displayed.
10. Press the
button to confirm the selection. The
appliance begins hot water delivery and the message
“Please wait” is displayed.
11. After the flow of hot water stops, the appliance automatically
resets to “Ready for coffee” status.
The new filter is now active and you can use the coffee machine.
13.3 Removing the filter
If you want to use the appliance without the filter (C4), you must
remove it and notify the appliance of its removal.
Proceed as follows:
1. Extract the tank (A7) and exhausted filter;
2. Press the
MENU/ESC
button (B3) to enter the menu;
3. Press < (B12) or > (B8) (fig. 9) until “Install filter, Installed”
appears on the display (B4);
4. Press the
button (B5);
5. “Uninstall?” appears on the display;
6. Press the
button to confirm and the
MENU/ESC
button to exit the menu.
14. TECHNICAL DATA
Voltage:
220-240 V~ 50/60 Hz max. 10A
Absorbed power:
1450W
Pressure:
1,5 MPa (15 bar)
Max. water tank capacity:
1,4 l
Size LxDxH:
195x410x330 mm
Cord length:
1750 mm
Weight:
10,4 kg (MB) - 11 kg (M)
Max. beans container capacity:
150 g
