12
13
hot water is delivered from the spout, heating the internal
circuits of the appliance and thus raising the coffee
temperature.
• place the cups on the cup warmer until they are warm.
• warm the cups by rinsing them with hot water (using the
hot water function).
• set the “high” coffee temperature (
llll
) in the
menu.
Making coffee using coffee beans
Important!
do not use caramelised or candied coffee beans as they could
stick to the coffee mill and make it unusable.
1. Fill the container with coffee beans (fig. 11).
2. Place under the coffee spouts:
- 1 cup, if you want to make 1 coffee (fig. 9);
- 2 cups, if you want 2 coffees (fig. 12);
3. lower the spouts as near as possible to the cup. This makes
a creamier coffee (fig. 13).
4. Press the button corresponding to the number of coffees
required (1 cup
or 2 cups
) (fig. 2 and 14).
5. Preparation begins. The quantity of coffee is displayed
together with a progress bar which gradually fills as
preparation progresses.
once the coffee has been made, the appliance prepares for use
again.
Please note:
• While the machine is making coffee, delivery can be
interrupted at any moment by pressing one of the coffee
buttons (
or
).
• at the end of delivery, to increase the quantity of coffee
in the cup, just press (within 3 seconds) one of the coffee
buttons (
or
).
once the coffee has been made, the appliance is ready to use
again.
Important!
if the coffee is delivered a drop at a time, too fast and not creamy
enough or too cold, read the tips in the “Troubleshooting”
section on page 19.
various alarm messages could be displayed while using the
machine. Their meaning is explained in the section “displayed
messages” (page 18).
Making coffee using pre-ground coffee
Important!
• Never add pre-ground coffee when the machine is off or it
could spread through the inside of the machine and dirty
it. This could damage the appliance.
• Never use more than one level
measure or it could dirty the inside
of the machine or block the funnel.
Please note!
if you use pre-ground coffee, you can only make one cup of
coffee at a time.
1. Press the
(C11) button: “Pre-ground” flashes on
the display.
2. Put one level measure of pre-ground coffee into the
funnel (fig. 14).
3. Place a cup under the coffee spouts (fig. 9).
4. Press the
delivery button (fig. 2).
5. Preparation begins. a bar appears on the display and
gradually fills as preparation progresses.
once the coffee has been made, the appliance prepares for
use again.To disable the pre-ground coffee function, press the
or
button again.
MAKING DRINKS WITH MIlK
Please note!
To avoid producing milk with poor froth or large bubbles,
always clean the milk container lid and hot water nozzle as
described in the section “Cleaning the milk container” and
“Cleaning the hot water/steam nozzle” (page 16).
Filling and attaching the milk container
1. remove the lid (fig. 16);
2. Fill the milk container with a sufficient quantity of milk,
not exceeding the MAX level marked on the handle (fig.
17).
Please note!
• For a denser more even froth, you must use skimmed or
partially skimmed milk at refrigerator temperature (about
5°C).
The quality of froth can be adjusted during delivery
by moving the regulator slightly towards the word
CAFFElATTE for less froth.
Moving it towards the word CAPPUCCINO obtains a
more froth.
• If “Energy Saving” mode is enabled, you may have to wait
a few seconds before the first cappuccino is delivered.
during this time, “Preparation underway...” is displayed.
3. Make sure the milk intake tube is correctly inserted in the
bottom of the milk container lid (fig. 18).
4. Place the lid back on the milk container.
5. remove the hot water spout from the nozzle (fig. 19).
6. attach the container to the nozzle, pushing as far as it will
go (fig. 20).
7. Follow the instructions for each function.
Making Cappuccino of latte Macchiato
1. attach the milk container (see previous section) and place
a sufficiently large cup under the coffee spouts and milk
spout.
2. Place the frothed milk regulator between “CaPPuCCino”
and “CaFFelaTTe” (fig. 21).
3. Press the
CAPPUCCINO
button
(fig. 22). “CaPPuCCino”
is displayed, together with a progress bar which fills
gradually as preparation proceeds.
4. after a few seconds, frothed milk flows out of the milk
spout into the cup below. if the froth is not satisfactory,
move the milk regulator towards “CaPPuCCino” (= +
froth) or towards “CaFFelaTTe” (= - froth). Milk delivery
stops automatically and coffee delivery begins.
5. The cappuccino is ready. Sweeten to taste and, if desired,
sprinkle the froth with a little cocoa powder.
Please note!
• If you want to interrupt preparation during delivery, press
the CaPPuCCino button.
• At the end of delivery, to increase the quantity of coffee
in the cup, just press (within 3 seconds) the CaPPuCCino
button.
• do not leave the milk container out of the refrigerator for
longer than strictly necessary. The warmer the milk (5°C
ideal), the poorer the froth will be.
Making frothed milk (without coffee)
To make frothed milk, proceed as described in the previous
section, placing the milk froth regulator in the CaPPuCCino
position and pressing the
CAPPUCCINO
button twice
consecutively (within two seconds) (fig. 22).
The appliance displays “Frothed milk” .
Please note!
if during delivery you want to stop making milk or coffee, press
the
CAPPUCCINO
button once.
Preparing milk (unfrothed and without coffee)
Proceed as described in the previous section, placing the milk
froth regulator in the CaFFelaTTe position.
+ froth
- froth
