DeLonghi ECAM35X.15 Series, Instructions For Use Manual

Page: 22 / 24

21
FLASH. + FLASH.
FLASHING
The water circuit is empty Turn the steam/hot water dial (A22) to the I posi-
tion until delivery stops, then bring it back to the
0 position. If the alarm occurs while hot water or
steam is being delivered, turn the dial to the
0
position. Turn the steam/hot water dial to the I
position until delivery stops, then bring it back to
the
0 position. If the problem persists, make sure
the water tank (A17) is fully inserted.
ON STEADILY
The inside of the appliance is very dirty Clean the inside of the appliance thoroughly,
as described in section “18. Cleaning”. If the
message is still displayed after cleaning, contact
Customer Services.
FLASHING
The infuser (A8) has not been replaced
after cleaning Insert the infuser as described in section “18.9
Cleaning the infuser”.
FLASHING
Indicates the steam/hot water dial (A22)
must be turned Turn the steam/hot water dial.
FLASHING
ESC + OK
ON STEADILY
The machine must be descaled The descaling procedure needs to be performed
as soon as possible (see section “19. Descaling”).
25. TROUBLESHOOTING
Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Custom-
er Services.
PROBLEM POSSIBLE CAUSE REMEDY
The coffee is not hot. The cups were not preheated. Warm the cups by rinsing them with hot
water (Please note: you can use the hot
water function).
The internal circuits of the appliance have
cooled down because 2/3 minutes have
elapsed since the last coffee was made. Before making coffee, rinse the internal
circuits by pressing the
icon (B15).
A low coffee temperature is set. Set a higher coffee temperature in
the menu (see section “9. Setting
temperature”).