DeLonghi ECAM35X.15 Series, Instructions For Use Manual

Page: 19 / 24

18
8. Position a container with a minimum capacity of 500ml
under the cappuccino maker/hot water spout (A20).
9. Deliver hot water by turning the steam/hot water dial
(A22) to the I position.
10. Deliver at least 500 ml of hot water, then turn the steam/
hot water dial to the O position.
The filter is now active and you can use the coffee machine.
21.2 Replacing the filter
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the filter:
1. Extract the tank (A17) and exhausted filter (C4);
2. Take the new filter out of its packet and proceed as de-
scribed in points 2 to 10 in the previous section.
The new filter is now active and you can use the coffee machine.
22. TECHNICAL DATA
Voltage: 220-240 V~ 50/60 Hz max. 10A
Absorbed power: 1450W
Pressure: 1.5MPa (15 bars)
Max. water tank capacity: 1.8 L
Size LxDxH: 240x440x360 mm
Cord length: 1150 mm
Weight: 9.2 kg
Max. beans container capacity: 300 g
This appliance complies with European regulation no.
1935/2004 on food contact materials.
23. DISPOSING OF THE APPLIANCE
The appliance must not be disposed of with house-
hold waste, but taken to an authorised waste separa-
tion and recycling centre.
medium
high
maximum
20.2 Setting water hardness
1. With the appliance off (standby), but the main switch
pressed (fig. 1);
2. Press and hold the icon (B9) until the icons on the
touch screen (B) come on;
3. Press the icon (B8);
4. Select the water hardness level by pressing the icon
again :
5. Press the OK icon (B15) to confirm (or ESC
(B14) to exit without making the change). The lights go off.
The machine is now reprogrammed with the new water hard-
ness setting.
21. WATER SOFTENER FILTER
Certain models are fitted with a water softener filter (C4). If this
is not the case with your model, you are recommended to pur-
chase one from De’Longhi Customer Services.
To use the filter correctly, follow the instructions below.
21.1 Installing the filter
1. Remove the filter (C4) from the packaging. The date indica-
tor disk varies according to the filter provided (fig. 26);
2. Turn the date disk to display the next 2 months of use.
Please note
The filter lasts about two months if the appliance is used nor-
mally. If the coffee machine is left unused with the filter in-
stalled, it will last a maximum of 3 weeks.
3. To activate the filter, run tap water through the hole in the
filter as shown in fig. 27 until water comes out of the open-
ings at the side for more than a minute;
4. Extract the tank (A17) from the appliance and fill with
water;
5. Insert the filter in the water tank and immerse it complete-
ly for about ten seconds, sloping it and pressing it lightly to
enable the air bubbles to escape (fig. 28).
6. Insert the filter in the filter housing (A18) and press as far
as it will go (fig. 29);
7. Close the tank with the lid (A16 - fig. 30), then replace the
tank in the machine;