16
(if provided) with a damp cloth and a little mild washing
detergent;
2. Remove the filter (C4) (if present) and rinse with running
water;
3. Replace the filter (if provided), fill the tank with fresh
water and replace the tank;
4. (Models with water softener filter only) Deliver about 3.38
floz/100ml of water.
17.7 Cleaning the coffee spouts
1. Clean the coffee spouts (A19) regularly with a sponge or
cloth (fig. 24A);
2. Check that the holes in the coffee spouts are not blocked.
If necessary, remove coffee deposits with a toothpick (fig.
24B).
17.8 Cleaning the pre-ground coffee funnel
Check regularly (about once a month) that the pre-ground
coffee funnel (A4) is not blocked. If necessary, remove coffee
deposits with the brush (C5).
17.9 Cleaning the infuser
The infuser (A8) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned off (see section
“5. Turning the machine off”);
2. Remove the water tank (A17);
3. Open the infuser door (A7) (fig. 25) on the right side of the
machine;
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (fig. 26);
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
Important!
RINSE WITH WATER ONLY
NO WASHING DETERGENT - NOT DISHWASHER SAFE
Clean the infuser without using washing detergent as it
could be damaged.
6. Use the brush (C5) to remove any coffee residues left in the
infuser housing, visible through the infuser door;
7. After cleaning, replace the infuser by sliding it onto the in-
ternal support, then push the PUSH symbol fully in until it
clicks into place;
Please note:
If the infuser is difficult to insert, before insertion, adapt it to the
right size by pressing the two levers (fig. 27).
8. Once inserted, make sure the two coloured buttons have
snapped out;
9. Close the infuser door;
10. Put the water tank back.
18. DESCALING
Descale the machine when the
light (B5) on the touch
screen (B) flashes and only the
OK
(B15) and
ESC
icons (B14) remain on.
To descale immediately, press
OK
and follow the instruc-
tions from point 4.
To descale the machine later, press
ESC
. The
light
flashes on the touch screen to remind you that the machine
needs descaling.
Important!
• Before use, read the instructions and the labelling on the
descaler pack.
• You should use De’Longhi descaler only. Using unsuitable
descaler and/or performing descaling incorrectly may re-
sult in faults not covered by the manufacturer's guarantee.
To descale the machine, proceed as follows:
1. Turn the machine off (standby) by pressing the
but-
ton (A24 - fig. 7) (see section “5. Turning the machine off”);
2. Empty the drip tray (A15) and grounds container (A11) and
put both back in the machine;
3. Press and hold the
icon (B8) until the
light (B5)
and the
ESC
and
OK
icons light up;
4. Empty the water tank (A17) completely and remove the
water softener filter (C4), if present;
5. Pour the descaler (C3) into the tank up to level A (corre-
sponding to a 3.38 floz / 100ml pack) marked on the inner
surface of the tank, then add a litre of water up to level B
(fig. 28) and put the water tank back in the machine;
6. Place a container with a minimum capacity of 1.8 litres
under the frother (A20) and coffee spouts (A19) (fig. 29);
Important! Danger of burns
Hot water containing acid flows from the frother and coffee
spouts. Take care to avoid contact with splashes of this solution.
7. Press the
OK
icon to confirm that you have added
the descaler solution. The descaling procedure begins;
8. After a few minutes, the
ESC icon (B14) flashes
to indicate the steam/hot water dial
(A23) must be
turned to the
I
position;
9. When the dial has been turned to the
l
position, the des-
cale programme starts and the descaler liquid comes out
of the frother. A series of rinses and pauses are performed
