DeLonghi ECAM28.46X, Instructions For Use Manual

Page: 14 / 24

13
2. Place under the coffee dispensing spouts, either:
- 1 cup if you want one coffee (fig. 14);
- 2 cups if you want 2 coffees.
3. Lower the spouts as near as possible to the cup. This
makes a creamier coffee (fig. 15).
4. Press the button corresponding to the number of coffees
required (1 cup or 2 cups , figs. 11 and
16).
5. Preparation begins. The amount of coffee selected is dis-
played together with a progress bar which gradually fills
as preparation progresses.
Please note:
• While the machine is making coffee, delivery can be inter-
rupted at any moment by pressing any button.
• At the end of delivery, to increase the quantity of coffee
in the cup, just press (within 3 seconds) one of the coffee
buttons (
or ).
Once the coffee has been made, the appliance is ready to make
the next drink.
Please note!
• Various alarm messages could be displayed while using
the machine (FILL TANK, EMPTY GROUNDS CONTAINER,
etc.). Their meaning is explained in the section “Displayed
messages” (page 20).
• For hotter coffee, see the section “Tips for a hotter coffee”
(page 12).
• If the coffee is delivered a drop at a time, too weak and not
creamy enough or too cold, read the tips in the “Trouble-
shooting” section on page 21.
Making coffee using pre-ground coffee
Important!
• Never add pre-ground coffee
when the machine is off or it
could spread through the inside
of the machine and dirty it.
This could damage the
appliance.
• Never use more than 1 level measure or it could dirty the
inside of the coffee maker or block the funnel.
Please note!
If you use pre-ground coffee, you can only make one cup
of coffee at a time.
1. Press the button (fig. 7) repeatedly until “Pre-
ground” is displayed.
2. Open the beans container lid; then open the pre-ground
coffee funnel lid by pushing on PUSH and, once released,
open the lid.
3. Make sure the funnel is not blocked, then add one level
measure of pre-ground coffee (fig. 17).
4. Place a cup under the coffee spouts.
5. Press the 1 cup coffee button
(fig. 11).
6. Preparation begins. The amount of coffee selected is dis-
played together with a progress bar which gradually fills
as preparation progresses.
Please note!
If “Energy saving” mode is enabled, you may have to wait a few
seconds before the first coffee is delivered.
MAKING DRINKS WITH MILK
Please note!
• To avoid producing milk with poor froth or large bubbles,
always clean the milk container lid and hot water nozzle
as described in the section “Cleaning the milk container”
on pages 17.
Filling and attaching the milk container
1. Remove the lid (fig. 18);
2. Fill the milk container with a sufficient quantity of milk,
not exceeding the MAX level marked on the container (fig.
19). Each mark on the side of the container corresponds
to 100 ml of milk.
Please note!
• For a denser more even froth, you should use skimmed or
partially skimmed milk at refrigerator temperature (about
5°C).
• If “energy saving” mode is enabled, you may have to wait
a few seconds before the first cappuccino is delivered.
3. Make sure the milk intake tube is correctly inserted in the
bottom of the milk container lid (fig. 20).
4. Place the lid back on the milk container.
5. Remove the hot water spout from the nozzle, by pressing
the button.
6. Attach the container to the nozzle and push as far as it
will go (fig. 21). The machine emits a beep (if the beep
function is enabled).
7. Place a sufficiently large cup under the coffee and frothed
milk spouts. Adjust the length of the milk spout. To move
it nearer the cup, simply pull it downwards (fig. 22).
8. Follow the instructions below for each function.