10
1� Remove the water tank, fill to the MAX line with fresh
water (fig� 1A) then put back in the appliance (fig� 1B)�
2� Place a container with a minimum capacity of 100 ml
under the cappuccino maker (fig� 2)�
3� Plug the appliance into the mains socket and place the
main switch on the back of the appliance in the
I
position
(fig� 3)�
4� The
light flashes on the control panel (fig� 4)�
5. Turn the steam dial to the “
I
” position (fig. 5). The
appliance delivers water from the cappuccino maker then
goes off�
6. Turn the steam dial to the “0” position.
The coffee maker is now ready for normal use�
Please note :
• When using the appliance for the first time, you need to
make 4-5 cups of coffee or 4-5 cappuccinos before the
appliance starts to give satisfactory results�
tURnInG the APPlIAnCe on
Please note :
• Before turning the appliance on, make sure the main
switch on the back of the appliance is in the
I
position (fig�
3)�
• Each time the appliance is turned on, it performs an
automatic preheat and rinse cycle which cannot be
interrupted� The appliance is ready for use only after
completion of these cycles�
Danger Of burns!
During rinsing, a little hot water comes out of the coffee spouts
and is collected in the drip tray underneath�
Avoid contact with splashes of water�
• To turn the appliance on, press the
(fig� 6): The
corresponding
light flashes while the appliance is
heating up and performing an automatic rinse cycle (by
circulating hot water, the appliance heats both the boiler
and the internal circuits)�
The appliance is at temperature when the light goes off and
the lights corresponding to the coffee buttons come on�
tURnInG the APPlIAnCe oFF
Each time the appliance is turned off, it performs an automatic
rinse cycle which cannot be interrupted�
Danger Of burns!
During rinsing, a little hot water flows from the coffee spouts�
Avoid contact with splashes of water�
To turn the appliance off, press the
button (fig� 6)� The
appliance performs a rinse cycle, then goes off�
Please note :
If the appliance is not used for an extended period, also place
the main switch in the
0
position (fig� 3)�
Important!
To avoid damaging the appliance, do not place the main switch
(fig� 3) in the 0 position until the appliance has been turned off
using the
button�
AUto-oFF
The appliance is set to turn off automatically if not used for 2
hours�
The time can be changed so that the appliance switches off
after 15 or 30 minutes, or after 1, 2 or 3 hours�
The set the auto-off, proceed as follows:
1� With the machine off and the main switch in I position
(fig� 3), press the
button and keep it pressed until the
lights on the control panel come on�
2� Press the
button (on the left side of the dial) until
the lights corresponding to the number of hours before
the appliance goes off automatically come on:
15 minutes
eCo
30 minutes
eCo
1 hour
eCo
2 hours
eCo
3 hours
eCo
3� Press the
button (on the right side of the dial) to
confirm; the lights switch off�
eneRGy sAVInG
Use this function to enable or disable energy saving mode�
When enabled, the function reduces energy consumption in
compliance with European regulations�
Energy saving mode is active when the green ECO light is on
(fig� 7)�
1� With the appliance off and the main switch in the I
position (fig� 3), press the
button and hold it down
until the
eCo
light comes on (fig� 7)�
2� To disable the mode, press the
button (on the left of
the dial)� The
eCo
light flashes�
3� To re-enable the mode, press the
eCo
button (on the left
of the dial)
again� The
eCo
light comes on steadily�
4� Press the
button (on the right of the dial) to
