49
OVEN FITTING OUT
•
Assemble the wire racks to the oven walls using the 2 screws (fig. 6.7a).
In the models with catalytic panels supplied
, interpose the catalytic panels “
A
” with
the arrow up (fig. 6.7a).
•
Slide the rack into the runners (fig. 6.7b).
The rack must be fitted so that the safety notch, which stops it sliding out, faces the
inside of the oven; the guard rail shall be at the back.
•
To dismantle, operate in reverse order.
Guard rail
Stop notch
Fig. 6.7b
Fig. 6.7a
A
ADVICE FOR USE AND MAINTENANCE OF CATALYTIC PANELS
The catalytic panels are covered with special microporous enamel which absorbs and does
away with oil and fat splashes during normal baking over 200°C.
If, after cooking very fatty foods, the panels remain dirty, operate the oven “idling” on max
temperature for about 30 minutes.
These panels do not require to be cleaned, however it is advised to periodically remove
them from the oven (at least the side panels) and to wash them with tepid soapy water and
then wipe off with a soft cloth.
DO NOT CLEAN OR WASH THEM WITH ABRASIVE PRODUCTS OR WITH PRODUCTS
CONTAINING ACIDS OR ALKALIS.
The side panels are reversible and when the catalytic microporous enamel degrades, they
can be turned to the other side.