7
2.5 Description of the milk container
(page 3 - E)
E1. Froth adjustment and CLEAN dial
E2. Milk container lid
E3. Milk container
E4. Milk intake tube
E5. Frothed milk spout (adjustable)
3. BEFORE USE
3.1 Checking the machine
After removing the packaging, make sure the product is com-
plete and undamaged and that all accessories (C) are present. Do
not use the machine if it is visibly damaged. Contact De’Longhi
Customer Services.
3.2 Installing the machine
Important!
When you install the machine, you should respect the following
safety warnings:
• The machine gives off heat. After positioning the machine
on the worktop, leave a space of at least 1.18 in / 3 cm be-
tween the surfaces of the machine and the side and rear
walls and at least 5.9 in/15 above the coffee maker.
•
Water penetrating the coffee machine could cause damage.
Do not place the machine near taps or sinks.
• The machine could be damaged if the water it contains
freezes.
Do not install the machine in a room where the tempera-
ture could drop below freezing point.
• Arrange the power cord (A21) in such a way that it cannot
be damaged by sharp edges or contact with hot surfaces
(e.g. electric hot plates).
3.3 Connecting the machine
Important!
Check that the main power supply voltage corresponds to that
indicated on the rating plate on the bottom of the machine.
Connect the machine to an efficiently earthed and correctly in-
stalled socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the machine,
have the socket replaced with a suitable type by a qualified
professional.
3.4
Setting up the machine
Please note!
• The first time you use the machine, the water circuit is
empty and the machine could be very noisy. The noise be-
comes less as the circuit fills.
• Coffee has been used to factory test the machine and it is
therefore completely normal for there to be traces of coffee
in the grinder. The machine is, however, guaranteed to be
new.
• You should customise water hardness as soon as possible
following the instructions in section "16. Setting water
hardness".
1. Connect the machine to the mains electricity supply (fig.
1). Make sure the main switch (A22) at the back of the ma-
chine is pressed (fig. 2);
2
1
Follow the instructions indicated on the machine display:
2. "SELECT LANGUAGE": Press and hold
until
the required language appears on the display, then press
the flag corresponding to the language.
4
33
3. "FILL TANK WITH" "FRESH WATER": remove the water tank
(A17) (fig. 3), fill to the MAX line (marked on the tank) with
fresh water (fig. 4, then place back in machine (fig. 5);
6
5
